1. When directly connecting the pump and motor for transmission, attention should be paid to the coaxiality between the pump shaft and the motor output; The accuracy of pump installation has a significant impact on the smooth operation and service life of the pump, so it is necessary to carefully install and calibrate it.
2. The pump coupling must be securely fastened with nuts and locked to prevent loosening, otherwise it may cause impeller displacement and mechanical failure.
3. In order to maintain a certain amount of storage liquid in the pump body, achieve better self suction capacity, and prevent dry friction of mechanical seals, it is necessary to make the inlet of the pump higher than the centerline of the pump shaft.
4. The installation of the suction pipeline should pay attention to:
A. The installation height of the suction port should not exceed 5 meters. When conditions permit, the installation height of the suction port should be as low as possible below the lowest water storage level of the pool, and the length of the suction pipe should be shortened as much as possible, with fewer elbows installed. This is beneficial for shortening the self suction time and improving the self suction function.
B. Valves, flanges, etc. in the suction pipeline should be strictly prevented from leaking air or liquid, that is, there should be no leakage in the suction pipeline.
C. To prevent solid and other debris from being sucked into the pump body, a filter should be installed on the suction pipeline. The effective drainage area of the filter should be 2-3 times the cross-sectional area of the suction pipe, and the filter should be regularly inspected.
Jan 03, 2024
Leave a message
Pump installation
Send Inquiry




